Announcements
IMPORTANT: Cypress Developer Community is transitioning on October 20th. To learn more and be prepared for this change, check out our latest announcement.
cancel
Showing results for 
Search instead for 
Did you mean: 

WICED Studio Wi-Fi Combo

KeVe_3565011
New Contributor

This may be a dumb question but I couldn't find the answer in the documentation. I am using WICED Studio & I have 2 CYW920719Q40EVB-01 boards that are connected via separate USB cords to the same computer that I would like to download & run different programs on using the WICED Studio IDE.

My question is: Is there a way to configure Make Targets in WICED Studio such that different USB/Serial ports are specified as part of the target instructions? My goal is to be able to develop different applications in WICED that I can quickly program to either board without having to plug & unplug wires (if possible). Thank you in advance!

-Kendall

0 Likes
1 Solution
Owen_Zhang123
Moderator
Moderator

1. Find the HCI UART Port in your device manager:

pastedImage_0.png

2. In the make target, add UART=COMx, such as "demo.hello_sensor-CYW920719Q40EVB_01 download UART=COM18"

Then you can program the specified target.

View solution in original post

2 Replies
Owen_Zhang123
Moderator
Moderator

1. Find the HCI UART Port in your device manager:

pastedImage_0.png

2. In the make target, add UART=COMx, such as "demo.hello_sensor-CYW920719Q40EVB_01 download UART=COM18"

Then you can program the specified target.

View solution in original post

KeVe_3565011
New Contributor

Exactly what I was looking for. Thank you so much!