- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi is there a document that describes how to properly install drivers for OpenOCD proper function in Wiced?
I had problems with Wiced 6.2.1 in both Win 7 and Win X
I am using PSoC6 Wifi BT Pioneer Kit CY8CKIT-062-Wifi-BT
I get KitProg2 UART USB in the device manager and also I can get the USB mass storage.
But I cannot get JTAG device on device manager.
So bottom line: Wiced does not work and stops with error "OpenOCD failed - ensure you have installed the driver from the drivers directory,"
while PSoCProgrammer works and it is able to connect to the device to get the flash readback.
could you please help on this?
Thank you
Solved! Go to Solution.
- Labels:
-
WICED Studio
-
Wifi+Bluetooth
-
Windows
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can run the DPInst_*64 if you are on a 64 bit machine or the DPInst if you are on a 32 bit machine for driver re-installation; both of which can be found at C:\Users\<User_name>\Documents\WICED-Studio-6.2.1\Drivers\Windows\wiced_uart. Please check the LED2 status before programming the device which should be off if you are using KitProg firmware newer than v 1.05.
When you face an OpenOCD error like this, the best place to start debugging the issue is by looking at the openocd_log.txt file generated as a part of the build procedure as located in 43xxx_Wi-Fi/build/openocd_log.txt. If you are still having difficulty in downloading through WICED Studio, please attach the device manager screenshot along with the openocd log for further debugging.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can run the DPInst_*64 if you are on a 64 bit machine or the DPInst if you are on a 32 bit machine for driver re-installation; both of which can be found at C:\Users\<User_name>\Documents\WICED-Studio-6.2.1\Drivers\Windows\wiced_uart. Please check the LED2 status before programming the device which should be off if you are using KitProg firmware newer than v 1.05.
When you face an OpenOCD error like this, the best place to start debugging the issue is by looking at the openocd_log.txt file generated as a part of the build procedure as located in 43xxx_Wi-Fi/build/openocd_log.txt. If you are still having difficulty in downloading through WICED Studio, please attach the device manager screenshot along with the openocd log for further debugging.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Perfectly working now!
LED2 must be off...
Thank you