Apr 11, 2019
02:15 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 11, 2019
02:15 PM
Just a simple question. Should the WL_REG_ON pin of CYW4343W be driven to VDDIO or VBAT to enable WiFi? I think its VDDIO, however its not 100% clear to me from the data sheet that this is correct. Just looking for confirmation on that. Thanks.
Solved! Go to Solution.
1 Solution
Apr 11, 2019
07:47 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 11, 2019
07:47 PM
Hello:
It is VDDIO, and mostly it will be connected to the HOST GPIO to control the on and off.
2 Replies
Apr 11, 2019
07:47 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 11, 2019
07:47 PM
Hello:
It is VDDIO, and mostly it will be connected to the HOST GPIO to control the on and off.
Apr 12, 2019
05:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 12, 2019
05:56 AM
Thanks for the reply. BTW I meant regulator not register.