Jan 14, 2015
06:05 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 14, 2015
06:05 PM
Dear Support,
For original design, the WP is Pin1, and the uart_DISABLE_EEPROM_WP_PIN32.hex is available in WICED-Smart-SDK-2.2.0\WICED-Smart-SDK\Platforms\BCM920736TAG_Q32.
We use the WICED to develop our product, and we also change GPIO setting. We move the WP to Pin32.
Could you provide uart_DISABLE_EEPROM_WP_PIN32.hex for Pin 32 setting ?
Best Regards,
Rush Chen
Solved! Go to Solution.
1 Solution
Jan 14, 2015
07:23 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 14, 2015
07:23 PM
3 Replies
Jan 14, 2015
07:23 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 14, 2015
07:23 PM
Jan 14, 2015
07:34 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 14, 2015
07:34 PM
Hi Sir,
Thank you and I will ask the BRCM local support.
But is it possible to change to Pin 32 without any cost ? Minor change or Major change ?
Best Regards,
Rush Chen
Jan 14, 2015
07:58 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 14, 2015
07:58 PM
The cost is probably not monetary but engineering effort that required for these changes to take effect in the fw.