- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
i have problem with fine timer ( 20737 + SDK 2.2.1).
When timer ( for example 100 ms or any ) is started ( on new empty project ) there is only few timer interrupts and then BCM goes to some hold or locked mode.
I use puart to debug and if i put print line in timer it looks like:
Timer start
0B000000000007021F00000000@$*#04FF1EF700920103000007362A0A00640000073A2A080000000007522A5000010đţ
Timer test cycle
Timer test cycle
Timer test cycle
@$*#04FFF6F70092032C7A0100362A100073200001000000002000508900000A00000000000000070010070F000F220000200000000000002A00008003BE1A000000008003AE1A040000008003B21A020000008003B61A050005008003BA1A032.. This data extends about 70 kb and after finishing transmitting BCM goes to sleep/locked/freeze mode.
It is same if i use led blink, buzz, or just leave timer interrupt empty.
Thanks.
Solved! Go to Solution.
- Tags:
- fine_timer
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
problem was that timer_fine cannot be used without initialized timer_1s to, and after initialization of both timers everything works fine.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Go here: Sleep Deep_Sleep Explanation and Techniques and review the portion of the blog about permanantly disabling sleep. See if this helps.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
problem was that timer_fine cannot be used without initialized timer_1s to, and after initialization of both timers everything works fine.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for updating the thread with the solution.