- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
another question .my 920737TAG03-HWUM100-R can not download my app . It always remand me that ( i use wiced smart )
I have tried as what it said but it always remand me this .
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Usually it is one of the following two issues:
1) Did you ensure that your FTDI chip is installed correctly? You should see an additional two serial com ports like below.
2) Did you ensure that your tag is in HCI (or download) mode by setting all switches on SW4 to ON?
Please refer to the below for more details.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
what i set as below
sw2 :VUSB
SW3:VREG
SW4: ALL ON
COM information as below
TAG SET AND information as below
pwm_tones-BCM920737TAG_Q32 download
pwm_tones-BCM920737TAG_Q32 download UART=COM17
pwm_tones-BCM920737TAG_Q32 download UART=COM18
is there some wrong with my board ?(HW)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Your serial ports are OK. And you should use the first one, COM17.
Your power supply settings and SW4 configurations are correct too.
I have included my own make target for hello_sensor and you can try it out. Do a clean build.
hello_sensor-BCM920736TAG_Q32 BT_DEVICE_ADDRESS=4040A13868A2 download UART=COM11
If all failed, then your EEPROM could be corrupted. Do a recovery procedure. Refer to the below doc.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
information
is it possible that,my board has been broken !!
but my app can run !
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Assuming you have followed the recovery instructions diligently, it is a possibility... My Cypress Beijing colleague will get in touch with you shortly.