- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hey,
I am a student and doing an internship at a company and they develop bus system devices.
So I have to create a prototype. For this i have the Evaluation Board BCM920732_BLE_KIT. I should connect this board with
their bus devices and create a new Bluetooth interface to check the status of a bus device with e.g. LightBlue or a iPhone app later.
For this i would connect the BCM920732_BLE_KIT at TP 32/33 (UART) with this bus device.
Is that possible with Evaluation Board BCM920732_BLE_KIT?
Or i would need the BCM92073X_LE_KIT ?
In future broadcom moduls fittet as standard in this bus devices for their customers.
Thanks
Asper
Solved! Go to Solution.
- Labels:
-
ispn:41241:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes.
You can pass custom_puart_config to bleapp_set_cfg() as 4th argument.
const BLE_PROFILE_PUART_CFG custom_puart_config = {
/*.baudrate =*/ 115200,
/*.txpin =*/ PUARTDISABLE | GPIO_PIN_UART_TX, // 32
/*.rxpin =*/ PUARTDISABLE | GPIO_PIN_UART_RX, // 33
};
P32 and P33 are available as TPs on the EVB.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes.
You can pass custom_puart_config to bleapp_set_cfg() as 4th argument.
const BLE_PROFILE_PUART_CFG custom_puart_config = {
/*.baudrate =*/ 115200,
/*.txpin =*/ PUARTDISABLE | GPIO_PIN_UART_TX, // 32
/*.rxpin =*/ PUARTDISABLE | GPIO_PIN_UART_RX, // 33
};
P32 and P33 are available as TPs on the EVB.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
OK, thanks a lot.