Announcements
IMPORTANT: Cypress Developer Community is transitioning on October 20th. To learn more and be prepared for this change, check out our latest announcement.
cancel
Showing results for 
Search instead for 
Did you mean: 

USB Superspeed Peripherals

SuWa_3337731
New Contributor

Hi,

We are using USB FX3 controller CYUSB3035-BZXC in one our design.

We are planning to use S-Port on FX3 controller for microSD card interface. As per the hardware guidelines document (http://www.cypress.com/file/139936/download),
all the microSD interface signals should be length matched and the length should not exceed than 5 inches .


In our layout, we kept the length of all these signals between 4.22 – 4.25 inches. Please let us know if we shall keep the length of all these signals same with tolerance of +/-0.030 inches. Please let us know if the clock signal should also be kept of same length or not?

Thanks & Regards,

Sunny Watts

0 Likes
1 Solution
SrinathS_16
Moderator
Moderator

Hello Sunny Watts,

- For reliable operation of the system, it is recommended that the data, command and clock traces of the device are length-matched. So, it is ideal to have the same lengths for all these lines.

- The mentioned tolerance value on the length-matching is fine.

Best regards,

Srinath S

View solution in original post

0 Likes
1 Reply
SrinathS_16
Moderator
Moderator

Hello Sunny Watts,

- For reliable operation of the system, it is recommended that the data, command and clock traces of the device are length-matched. So, it is ideal to have the same lengths for all these lines.

- The mentioned tolerance value on the length-matching is fine.

Best regards,

Srinath S

View solution in original post

0 Likes