Announcements
IMPORTANT: Cypress Developer Community currently doesn’t allow sign-in to prepare for the upcoming transition. To learn more, check out our announcement.
cancel
Showing results for 
Search instead for 
Did you mean: 

USB Superspeed Peripherals

WGT_4383351
New Contributor II

Commonly if you want to redebug a board with JTAG connected, what ever the status the board is, you just end the current debug and begin the new debug session.

According to the documents, now if you want to redebug CYUSB3KIT-003 like debug a modified version, then you need to :

(1)End debug

(2)End gdb and OpenOCD

(3)Reset  the board by press the reset button

(4)Redebug

This is very complex.

Is there easier way?

0 Likes
1 Solution
YashwantK_46
Moderator
Moderator

Hello,


Please go through the following link: Eclipse and JTAG debugging: Run / Debug buttons

Please read the last interaction which gives a possible way to do what you want to implement.

Regards,

Yashwant

View solution in original post

0 Likes
5 Replies
YashwantK_46
Moderator
Moderator

Hello,

Can you elaborate what you meant by "modified version"?

Do you mean, changing the firmware and rebuilding the firmware image?

Or just using the existing firmware image and restarting the debug session again?


Regards,
Yashwant

0 Likes
WGT_4383351
New Contributor II

Both - anything that is common during debug.

0 Likes
YashwantK_46
Moderator
Moderator

Hello,


Please go through the following link: Eclipse and JTAG debugging: Run / Debug buttons

Please read the last interaction which gives a possible way to do what you want to implement.

Regards,

Yashwant

View solution in original post

0 Likes
WGT_4383351
New Contributor II

It says "Error stopping at main Reason:target request failed:failed to interrupt"

0 Likes
YashwantK_46
Moderator
Moderator

Hello,

Apologies for the delay.

Can you please share a snapshot of the error message?

Can you please tell what you exactly did when you see the error?


Regards,

Yashwant

0 Likes