Redebug CYUSB3KIT-003 from PC

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
WGT_4383351
Level 5
Level 5
First like received

Commonly if you want to redebug a board with JTAG connected, what ever the status the board is, you just end the current debug and begin the new debug session.

According to the documents, now if you want to redebug CYUSB3KIT-003 like debug a modified version, then you need to :

(1)End debug

(2)End gdb and OpenOCD

(3)Reset  the board by press the reset button

(4)Redebug

This is very complex.

Is there easier way?

0 Likes
1 Solution

Hello,


Please go through the following link: Eclipse and JTAG debugging: Run / Debug buttons

Please read the last interaction which gives a possible way to do what you want to implement.

Regards,

Yashwant

View solution in original post

0 Likes
5 Replies
YashwantK_46
Moderator
Moderator
Moderator
100 solutions authored 50 solutions authored 50 likes received

Hello,

Can you elaborate what you meant by "modified version"?

Do you mean, changing the firmware and rebuilding the firmware image?

Or just using the existing firmware image and restarting the debug session again?


Regards,
Yashwant

0 Likes

Both - anything that is common during debug.

0 Likes

Hello,


Please go through the following link: Eclipse and JTAG debugging: Run / Debug buttons

Please read the last interaction which gives a possible way to do what you want to implement.

Regards,

Yashwant

0 Likes

It says "Error stopping at main Reason:target request failed:failed to interrupt"

0 Likes

Hello,

Apologies for the delay.

Can you please share a snapshot of the error message?

Can you please tell what you exactly did when you see the error?


Regards,

Yashwant

0 Likes