Announcements
IMPORTANT: Cypress Developer Community is transitioning on October 20th. To learn more and be prepared for this change, check out our latest announcement.
cancel
Showing results for 
Search instead for 
Did you mean: 

USB Superspeed Peripherals

Anonymous
Not applicable

I have a  ZTEX FPGA board  with CYUSB3033x Device combined with Xilinx 7 series FPGA  which has FX3 capability.

In this example of FX2LP with ZTEX FPGA boards, it is said that we have to add CyUsb.sys for configuring firmware.

http://www.cypress.com/file/44551/download

In FX3,  configuring USB devices with USb Control Center requires CyUsb.sys driver. There is an example for adding a device with 0x4B4 which is Cypress USB ID in CyUsb.pdf

However, there is no example for adding devices with different USB ID's.

I want to configure my ZTEX 2 series board with USB Control Center, to make it I need cyusb3.sys driver. Although I follow all of the steps on FX3 cyusb3.sys device adding my device cannot work in Windows 8.1.

Are there any example for adding different vendor ID device on cyusb.sys ?

or are there any trick or method adding non-cypress devices on cyus.sys?

0 Likes
1 Solution
SrinathS_16
Moderator
Moderator

Hello Eren Tansel,

Please refer to the Cypress CYUSB3.SYS Programmer's Reference from the below link

http://www.cypress.com/file/145261/download

In this document, the Section 2: Modify CYUSB3.INF contains the procedure for modifying the INF file to include custom VID/PID.

Best regards,

Srinath S

View solution in original post

0 Likes
1 Reply
SrinathS_16
Moderator
Moderator

Hello Eren Tansel,

Please refer to the Cypress CYUSB3.SYS Programmer's Reference from the below link

http://www.cypress.com/file/145261/download

In this document, the Section 2: Modify CYUSB3.INF contains the procedure for modifying the INF file to include custom VID/PID.

Best regards,

Srinath S

View solution in original post

0 Likes