FX3 I2C-GPIO60_CHARGER-DETECT (D11) is NC now ?!

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
vaogc_284256
Level 1
Level 1

Hi,

In new revision *W of document "CYUSB301X/CYUSB201X, EZ-USB® FX3: SuperSpeed USB Controller"

pin D11 or GPIO[60], which was an output is now labled as NC pin without any explanations.

I successfully used this pin as output earlier. Why is it NC now? Can I continue to use in with new revisions of fx3 chip silicon?

Regards

0 Likes
1 Solution

Hi Vaagn,

It doesn't matter for you. You could continue to use it as GPIO.

View solution in original post

0 Likes
3 Replies
YangyangC_06
Employee
Employee
750 replies posted 500 replies posted 250 replies posted

Hi Vaagn,

Could you please explain your application in detail? Are you using ACA based charger detection or the standard battery charger detection?

0 Likes

Hi yyca,

I don't use or ever need charger detection logic. But I use this pin as general purpose output by CyU3PGpioSetValue(...)

0 Likes

Hi Vaagn,

It doesn't matter for you. You could continue to use it as GPIO.

0 Likes