Announcements
IMPORTANT: Cypress Developer Community is transitioning on October 20th. To learn more and be prepared for this change, check out our latest announcement.
cancel
Showing results for 
Search instead for 
Did you mean: 

USB Low-Full-High Speed Peripherals

Anonymous
Not applicable

 i have write a  firmware, and use the kneil 4 to compile it, when output, i use the command as below:

   

   

Hex2bix.exe -i  -o bulktogpif.iic bulktogpif.hex -f 0xC2 -v 0x0451 -p 0x32AF

   
    the i use the control center download it to EEPROM, and the software show it programmed successfully, and i also load    
   
    the sprit file and display the sprit,   
   
        
   
    But, it seems that the usb is started as the C0 mode,    
   
        
   
    can you help me, how can i know whether EEPROM is programming successfully and the 68013 is working by load the firmware which is written by myself?   
0 Likes
1 Reply
Anonymous
Not applicable

 Hi ,

   

Please share the .*iic file which you have used to program the EEPROM. you can read the contents of EEPROM by using some vendor commands. Refer vend_ax example avaialble in the path (C:\Cypress\USB\CY3684_EZ-USB_FX2LP_DVK\1.0\Firmware)after installing CY3684. Also refer the application note in the following link      http://www.cypress.com/?docID=41632.

   

if possible share the firmware also.

   

 

   

Regards,

   

Vikas.

0 Likes