Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
Hello! I am try to use CY7C68003 with my FPGA chip. Now I can say for CY7, what generator I use: I send the pulses on RESET, the CLOCK signal is begin - that is all right. After 10 pulses of CLOCK, whan the DIR signal is surely stay in '0', I sent my TX CMD. For simplicity I only write the register USB Interface Control, to run the work of port with current settings. I set the DATA bus into B5h (to write register 35h), wait the signal NXT='1' and set DATA=04h (to set bit UsbEnable to '1'). And then, after the falling edge of my STP signal, the CY7 stop generation of CLOCK. What I do incorrectly?