- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Manuel
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
... Also forgot to mention that our .HEX file for the FX1/FX2LP is 9619 bytes in size and always loads totally fine on the new hardware using the same load routines of our software and/or CyConsole/CyControl.. regardless of size.
... while our firmware for the older FX hardware is only 4138 bytes... but fails to load using the same load routines of our software and/or CyConsole/CyControl (with the added chages for CPUCS address RESET and maximum internal address value) DEPENDING on size.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please create a tech support case at www.cypress.com -> Support -> Tech support. One of our engineers will take a look at the issue and will help you out.
Regards,
Gayathri
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I actually did end up opening a case for this problem (Case # 1887119173)... but still wanted to see on here if someone else has run into this similar problem.
Thanks,
Manuel
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Noted the case number. We would be supporting you through the case.
Regards,
Gayathri
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is there a resolution to this issue? We have a similar situation and like to know if we can move away from the two satge driver (ezloader.sys then ezusb.sys) and use CyUSB.sys and script instead for some old devices.
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Yes we do have a resolution for this. Ffirmware download to FX using CyUSB.sys is seen to have issues when done in chunks greater than 64 bytes. We have a utility that generates scripts which does the firmware download in chunks of 64 bytes. Please create a tech support case where we can share you more details.
Regards,
Gayathri
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Yes we do have a resolution for this. Ffirmware download to FX using CyUSB.sys is seen to have issues when done in chunks greater than 64 bytes. We have a utility that generates scripts which does the firmware download in chunks of 64 bytes. Please create a tech support case where we can share you more details.
Regards,
Gayathri