PSoC™ Creator & Designer Forum Discussions
I am transferring a PSoC5 project from creatoe 2 to 5LP using creator 3
While was trying different hardware arrangment and build the project, I had this error shown up.
"The background elaborator has encountered a problem. Out of memory."
However, the project just contnue to build without problem. and that error would stayed there until I close and re-open the work space.
Anyone had this error?
Show LessI ran into a problem which I cannot reproduce.
When setting a pin to Open Drain Low (ODL), I could not get the pin
to take a StdCPU setting simultaneously. The only way I could
get it to take ODL was to set pin to a global out buss (I was working on
an output pin) rather than StdCPU..
After exiting Designer, and re-entry, it now allows me to set ODL pin to StdCPU,
and cannot reproduce error.
Ghosts.
Regards, Dana.
Show LessI use often the LED component to effect an API driven GPIO pin control
in code. But it would be great if this utility was offered in another form,
say call it GPIO, and expand it to allow different drive modes, like open
drain, as well as interrupt,……etc..
Regards, Dana.
Show LessIn the doc download for Miniprog1 there is no schematic of the
Miniprog1 internals. There have been questions, in past and recent,
about circuit effects with Miniprog1 connected to a users header and
unconnected.
It would be useful to supply that schematic with the docs.
Regards, Dana.
Show LessIn the module datasheets you have the following issues -
1) Analog mux, you give a selttling time with out any attached resolution. There
should be a table of times vs resolution to 20 bits, down to 8 bits.
2) S/H, same problem, you only spec to 1% which is ~ 7 bits, not really a useable
number for worst case design. Again a table from 8 to 20 bits.
3) You should show in applicable datasheets how to calc settling time to worst
case for a first order R-C network so users can calc their own design. Calc to 1/2 LSB.
Regards, Dana.
Show LessMy other audio experiment - Chaotic percussion generator
Include this beta components:
Percus A B C - simple percussion generators (different waveforms)
Logistic - is logistic map generator (from periodic to chaos)
Bool_Chaos - is simple logic semi-chaotic pulse generator
PSoC5LP Bootloadable project for Pioneer Kit and P3[0] (P3[7]) pin output
Kamil
Show LessThis a project for the LCD from the MOTOROLA T191 (98x64).
Low price, easy connection.
I hope someone will come in handy
Show LessI'm so glad to used the DDS modules by many friends,
They told me that there are many applications of DDS.
There is no necessarily of sine wave is in always,
Some application needs more high frequency
and that is enough as pulse wave.
Hence this time
I was made a IQ-DDS module
It is upto 5MHz and Minimum frequency resolution is 2.86Hz at 48MHz clock.
This test bench is implemented to Pioneer-Kit, Bootable PSoC5LP
How to is describe in this article, 9.OCT.2013
[ http://www.cypress.com/?app=forum&id=2492&rID=86654 ]
Would you mind to make a SDR Radio.
Have a nice days. Show Less