PSoC™ Creator & Designer Forum Discussions
Would it be possible, or are there plans to add configurability of the GDB server settings in PSoC Creator?
I know PSoC Creator is using GDB under the hood, which connects to the default cypsocdebugger. This built in GDB-server lacks some serious functionality (for example floating point registers, ability to connect to different programmers, use PSoC6 with locked CM0p etc.).
We sadly lost a potential big customer because cypsocdebugger is not able to debug PSoC6 with locked CM0p.
-Rolf
Show LessDear All,
Does the CY8C24794 can implement the PSoC creator ? So far, I know the chip only available to compile in PSoC designer. I am new in cypress so wish to know whether the chip can support in PSOC creator.
Thanks.
Regards,
John
Show LessPast a few years I have been successfully using PSoC 4.2 ...
My Laptop recently crashed. I have formatted and reloaded Windows 7.
Shows error - image attached.
I have successfully loaded PSoC Programmer 3.29.0....
Please help...
Vittal
Show Lessunable to install kit packages on PSoC Creater 4.4. When i try to do update on cypress update manager, I get the message, "unable to get updates frome update server "
please help me!
Ammar
Show LessWhen comparing USB descriptors between versions, I noticed the serial number changed after updating the USBFS component. Is this documented somewhere? I don't see anything in the USBFS datasheet.
Previously it was 161409CB00218400, changed to 090500CB84211614, which sort of looks like a shuffling of the bytes but not exactly...
Show LessHi all!
I am trying to add an or gate into a PSOC4 CYBLE-212020-01 but I can´t find it in the component catalog. I`ve checked my proyect dependencies and CyPrimitives are included so I don´t know how to add it into my project.
Thanks!
Show LessHello everyone,
I generated the Code for a LIN slave in Psoc Creator because my ECU is a LIN slave.
I have an SBC which is connected to the microcontroller and this SBC should be configured during Startup via SPI.
While checking the generated Code I saw that the LIN slave is configured in UART mode and the functions for SPI are not generated.
Could you please let me know, how can I switch to SPI mode to send the commands to the SBC and switch back afterwards to the UART mode to start LIN communication?
Thanks and Regards
Show LessI am using windows 10 and can't download the PSoC Creator 4.4. I can't figure out why this is. I walked with a rep and neither of us could figure it out. Any help would be appreciated.
Show Less