PSoC™ 6 Forum Discussions

Hi. I have zero knowledge of SW. I'm a hardware engineer. Could you step by step with pictures and code examples explain how to assign PWM signals to certain pins of the board when some events appear? I use MTB but have no idea how to do it...v Maybe let's do it together?

Hello I'm trying to run ble using CY8CPROTO-063-BLE and configure as an hid service to send keystrokes to the host. I tried following examples published here https://github.com/Infineon/PSoC-6-MCU-BLE-Connectivity-Designs

but was not able to successfully implement. Wondering if someone can point me to some updated examples or resources. 

Thanks in advance

my board is CYW20829
When I was writing my BLE program based on RTOS, I created some other tasks and ran the program, which caused Bluetooth to fail to initialize, meaning it could not start. The program only printed the content before Bluetooth initialization.

/* Initialize bluetooth porting layer by setting HCI configuration */

cybt_platform_config_init( &cybsp_bt_platform_cfg).

/* Register call back and configuration with stack */

result = wiced_bt_stack_init(app_bt_management_callback,

&wiced_bt_cfg_settings).

/* Check if stack initialization was successful */

if( WICED_BT_SUCCESS == result)

{

printf( "Bluetooth Stack Initialization Successful \n ");

}

else

{

printf( "Bluetooth Stack Initialization failed!!! \n ");

CY_ASSERT(0).

}

The program printed Bluetooth Stack initialization successfully on the terminal, but it seems that the program is stuck in a certain task, causing The program printed Bluetooth Stack initialization successfully on the terminal, but it seems that the program is stuck in a certain task, causing I would like to ask what direction I should take to solve this problem when it arises. (Note: I modified it using the modustoolbox BLE routine).In other words, under what circumstances will Bluetooth fail to start

smartconx_target@Q!w2e3r4t5y6u7i8o9p0||/t5/PSoC-6/Regarding-the-issue-of-Bluetooth-not-starting-properly-when-programming-with/td-p/735250

I am using CYBLE416045-02.

I have used the example code PSoC6DfuBleApp001.cydsn and PSoC6DfuBleApp011.cydsn to add the bootload application to my application code.

In my application code, when there is no BLE connection being made after 5 minutes, I will put the device into hibernate mode.

However, instead of hibernating, the device returns to the bootload mode and then loads the application program.

The below is the code to implement the hibernate mode.

Can anyone advise on the likely issue?

Thank you.

 /* Restart 1s timer */
if(mainTimer != 0u)
{
if(!bDeviceConnected)
{
if(++nSleepTimeOutCnt==300)
{ // check for 5 mins of no activity
STATUS_LED_Write(LED_OFF); // turn off
Cy_SysPm_Hibernate(); // go to hibernate
}
}
mainTimer = 0u;
Cy_BLE_StartTimer(&timerParam);
}