Announcements
IMPORTANT: Cypress Developer Community is transitioning on October 20th. To learn more and be prepared for this change, check out our latest announcement.
cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 6 MCU

damac_4222651
New Contributor

I want to make automatic empty bottle detection system as describe in the link https://instrumentationtools.com/automatic-empty-bottle-detection/

I want to use a microcontroller in place of PLC and also using an encoder to reject object at an accurate position

Which PSoC Board would be suitable for my project?

0 Likes
1 Solution
Bob_Marlowe
Expert II

A CY8CKIT-043 PSoC4-M Prototyping kit will be able to perform that job. You will probably need some level shifters to connect to the non-5V environment of the asset. Take care for noise in industrial environment: use shielded signal cables only and connect all shields to a single ground point. When at a later point you want to connect your interface using BLE you may add a PRoC module to the board.

Bob

View solution in original post

3 Replies
Bob_Marlowe
Expert II

A CY8CKIT-043 PSoC4-M Prototyping kit will be able to perform that job. You will probably need some level shifters to connect to the non-5V environment of the asset. Take care for noise in industrial environment: use shielded signal cables only and connect all shields to a single ground point. When at a later point you want to connect your interface using BLE you may add a PRoC module to the board.

Bob

View solution in original post

damac_4222651
New Contributor

Thanks Bob

I would order CY8CKIT-043 PSoC4-M Prototyping kit

Which  PRoC module need to interface with the board?

I found this https://www.evelta.com/boards-kits-and-programmers/wireless-development-tools/CYBLE-212020-EVAL?lang...

0 Likes
ShipingW_81
Moderator
Moderator

The PRoC module you mentioned looks fine for your design.

0 Likes
Top labels