After lots of experience with PSoC 3, 4, 4 BLE, and 5LP, I'm trying to get some experience with the PSoC 6. I'm using the CY8CPROTO-063-BLE prototyping kit with the CYBLE-416045-02 EZ-BLE module on it.
I started with the CE221773 PSoC 6 Hello World example and that ran without any issues. I'm now trying to run the CE212736 Fine Me example, with the LEDs removed (because there's no RGB LED on this kit, and I can use the UART to see what's going on). I'm doing this in PSoC Creator 4.2 with PDL 3.1.0.
If I debug the M0+ core, I can see that it successfully starts the BLE stack and then tries to start the M4 core. If I debug the M4 core, execution never reaches main().
Anybody know what's going on here?
(Project attached even though it's just the Cypress example with the changes mentioned above)@
Solved! Go to Solution.