Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
Just received a CY8CKIT-030 today. The quick step guide shows to plug in the USB cable and watch the pot vary the voltage. My problem, the board first performs a self test. It gets to the LED test and continues to blink LED 3 and 4. No more action on the board.
I looked for documentation about the self test, and could not find it. Any help possible on what to do now ?
Hi there, its just that the firmware that was loaded is a self test firmware that is used at the factory to test if everything is working fine. The board should be perfectly alright. You dont need to return the kit to cypress. Please insert the CD that comes with the the kit and install the software. It also installs the firmware that is assocaited with the kit you can load that firmware in to the kit from PSoC Creator and get started with the kit. Please go to this page to get started with PSoC3, http://www.cypress.com/?id=2232&tabID=38386