PSoC™ 5, 3 & 1 Forum Discussions
text.format{('custom.tabs.no.results')}
Enjoy! 🙂
A few questions:
Is April 25th the day that the whole project must be at Cypress?
What do we do about software parts to a project? I have a PC python script that is custom to my design.
What is the best way to ship the design? I want to ship the design the way it is with my jumper wires connected so that the judges only have to turn it on and see it operational.
DiodeDan
Show LessI made a 'hardware only' enabled UDB timer that flashes an LED according to the attached schematic. The main() routine contains nothing but an endless loop. I can't get this to work unless I put 'Timer_1_Start()' in the main routine. According to the data sheet this should not be necessary. Any suggestions?
Show LessCan any one tell how can we place resistor and capacitor and configure thier values in the PSOC design in the workspace of psoc creator so that we can add them to other blocks.????
Show LessIs it possible to change the drive mode of a certain PIN at runtime for C Code.
In my application I have defined P3[7] as "Pull Up" in the IDE, I want to change it to "Pull Down" at runtime.
My best guess how to do this is code like this ...
PRT3DM1 |= 0x80 PRT3DM0 |= 0x80
In other examples I've seen stuff about 'disconnect from global bus', would I need to do this as well?
Show LessHallo,
I have a doubt about handling a communication with a couple of I2C slaves. If I usually perform:
a write on the first slave, a read from the first slave, a write to the second slave, a read from the second slave
If one of that functions takes too much time I simply skip on the next task simply clearing the read/write status.
The question is: "I have to send a stop the the slave before dropping the task I was executing with him"?
Show Less