Oct 12, 2017
10:37 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 12, 2017
10:37 PM
Hi there
I would need to know how set the start bit on Uart V 2_.50.
I need to comunicate with a device which needs: 1start, 1 stop, 8 bit, no parity.
Thank you.
Solved! Go to Solution.
Labels
- Labels:
-
PSoC 5 Device Programming
-
PSoC 5LP
1 Solution
Oct 12, 2017
11:43 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 12, 2017
11:43 PM
A new frame is recognized by the falling edge at the beginning of the active-low Start bit
Please go through the page#39 of this Component datasheet-
2 Replies
Oct 12, 2017
11:43 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 12, 2017
11:43 PM
A new frame is recognized by the falling edge at the beginning of the active-low Start bit
Please go through the page#39 of this Component datasheet-
Oct 13, 2017
07:23 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 13, 2017
07:23 AM
Thak you very much Anks