- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You have to download PSoC Creator, not Designer.
[ http://www.cypress.com/?id=2494&source=support ]
And also you can download Software of DEVKIT-050
[ http://www.cypress.com/?rID=51577 ]
CY8CKIT-050 PSoC 5LP DVK Setup (Kit Design Files,
Creator, Programmer, Documentation, Examples)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
PSOC Designer is used to write code for the PSOC1 devices. You will need to install PSOC creator for the PSOC3, PSOC4 and PSOC5.
The landing page for the kit is :
http://www.cypress.com/go/cy8ckit-050
there you can find a link to download PSOC creator and an archive with the fuill documentation and code examples. You can also download an DVD Image (ISO file) with the full contents of the kit's DVD to burn on a blank media or mount on a virtual drive.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
zeta and I said use Creator, not Designer.
Don't miss
.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The -050 kit had a change in silicon on it. Does your kit have a PSOC 5LP part on it ?
Or the older PSOC 5 ? PSOC 5LP is the recommended part of choice for PSOC 5
designs. If you have the older board you can get an upgraded board from www.cypress.com/
and www.cypress.com/go/psockitupgrade
If the board P/N is CY8C5568AXI-060 TQFP100 that is the older board.
Regards, Dana.