Announcements
IMPORTANT: Cypress Developer Community is transitioning on October 20th. To learn more and be prepared for this change, check out our latest announcement.
cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

Anonymous
Not applicable
        Hi, everyone. I would like to get the output signal from CLOCK and INPUT SIGNAL. Please see attached file. In this case how should I use PSoC1?   
0 Likes
4 Replies
Anonymous
Not applicable
        Sorry. I made dubble post. How can I delete this post?   
0 Likes
ETRO_SSN583
Esteemed Contributor

Several methods, but use a 16 bit counter (it counts down) and set period

   

to 495 pulses, compare value to 480, compare logic to "<=". So when enabled

   

(HW or SW enable) counter starts at max val (495) and when it hits 480 compare

   

output goes high, stays high until rollover from 0 back to 495.

   

 

   

0 Likes
ETRO_SSN583
Esteemed Contributor

You cannot delete double posts, forum SW not capable. Has to be

   

done by webmaster, don't worry about it.

   

 

   

Regards, Dana.

0 Likes
Anonymous
Not applicable
        Thank you for your reply. I will check and come back when I have enough time to do. Sincerely yours,   
0 Likes