Attachments are accessible only for community members.
Anonymous
Not applicable
Dec 16, 2013
05:47 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 16, 2013
05:47 AM
Hi, everyone. I would like to get the output signal from CLOCK and INPUT SIGNAL. Please see attached file. In this case how should I use PSoC1?
Labels
- Labels:
-
PSoC 1
4 Replies
Anonymous
Not applicable
Dec 16, 2013
05:52 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 16, 2013
05:52 AM
Sorry. I made dubble post. How can I delete this post?
Dec 16, 2013
05:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 16, 2013
05:56 AM
Several methods, but use a 16 bit counter (it counts down) and set period
to 495 pulses, compare value to 480, compare logic to "<=". So when enabled
(HW or SW enable) counter starts at max val (495) and when it hits 480 compare
output goes high, stays high until rollover from 0 back to 495.
Dec 18, 2013
06:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 18, 2013
06:12 AM
You cannot delete double posts, forum SW not capable. Has to be
done by webmaster, don't worry about it.
Regards, Dana.
Anonymous
Not applicable
Dec 19, 2013
04:23 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 19, 2013
04:23 AM
Thank you for your reply. I will check and come back when I have enough time to do. Sincerely yours,