Announcements
IMPORTANT: Cypress Developer Community is transitioning on October 20th. To learn more and be prepared for this change, check out our latest announcement.
cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

Anonymous
Not applicable

Hi,

I want to develop control unit for burner,  kindly advise me, which board kit is near to match my requirements .!

   

 

   

I want to control burner flame with pressure and temperature sensors and three units are attached with burner working.

1: System start up with ( control : Monitor pressure and Temp by sensors )
2: Glow Plug 12v 17A (control : switch on/off with timer + Temp sensor )
3: Blower fan 12V 11A, ( Control : switch on/off + PWM variable speed + temp sensor
4: Fuel Pump 12V, 4A, PWM ( Control : Switch on/off + variable speed + temp sensor

Burner system will start up when Pressure and Temp will reached at desired level.
1st glow plug will on for produce flame , 2nd blower will on with low flow, 3rd fuel pump will on for produce continuous flame,


1: MCU 32Bit Cortex M4 200Mhz
2: Flash 2mb + Accelerator
3: Ram 512
4: 2USB + 2 CAN
5: Ethernet IEEE 1588
6: ADC 8
7: Power on/off 6 Mofsets
8: Temperature Sensor 6
9: Pressure Sensor 6
10: Jtag header
11: TFT controller + LCD
10: I/O 20
11: Multi Function Alarms 4 +RTC
12: PWM 8

   

 

   

Awaiting your helpful reply.

Regards
Sami

0 Likes
2 Replies
Bob_Marlowe
Expert II

Spamming the forum with the same question all over is really a bad habit!

   

 

   

Bob

0 Likes
AnkitaS_51
Employee

Presently ,PSoC has no Ethernet IEEE 1588 support

0 Likes