Announcements
IMPORTANT: Cypress Developer Community is transitioning on October 20th. To learn more and be prepared for this change, check out our latest announcement.
cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 5, 3 & 1 MCU

Anonymous
Not applicable

Dear All

I have a problem with CY8CKIT-001 Rev*B development board and CY8C58LP Processor Module Rev**. There is the MiniProg3 connected to the processor module. The "Port Acquire" command from "PSoC Creator 4.2 -> Select Debug Target" returns an error "There was an error running port acquire: Can not acquire SWD device!"

The same operation performed on this development board populated with the old CY8C55 processor module succeeds. Of course, further work with PSoC Creator is not possible in such configuration.

My question is if it is an incompatibility issue between different revisions of development board (Rev**) and 5LP processor module (Rev*B) or the CY8C58LP Processor Module is probably damaged.

Best regards

   Grzegorz

1 Solution
Bob_Marlowe
Expert II

CY8C58LP Processor Module is probably damaged?

You may connect your Miniprog3 directly to to the processor module without using the -001 baseboard. This will show you  if it works correctly.

Bob

View solution in original post

1 Reply
Bob_Marlowe
Expert II

CY8C58LP Processor Module is probably damaged?

You may connect your Miniprog3 directly to to the processor module without using the -001 baseboard. This will show you  if it works correctly.

Bob

View solution in original post