Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
I am trying to make a 4 channel battery analyzer. In the design I am using an 8 channel AMux ahead of the DelSig ADC to allow the selection of 4 battery voltages on GPio
pins as well as the DAC (4) voltages that are buffered by 4 internal opamp followers. In operation the AMux goes through the 8 channels sequentially and all is well until it gets to channel 7 (last) which it always reads low. The channels are read 800 times a second at which time an average over the second is computed. Attached is the project.
Also, the ADC does not seem to do well under 80 mV even when in single ended mode which gos through zero.