- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi All
I want to use the PSoC_4_BLE_DTM.hex to test the HCI mode.
I connect the UART to P0.1 and P0.0.
But I don't find the dialog following.
What can I do?
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Open the "TopDesign" window in the workspace explorer. Here you find all the components that have been selected for the project. When there is no BLE component yet, pick it from the component window and drop it onto your schematic. Now configure it accordingly (right click or double click)
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
If you double click the BLE Component Settings, you can see this dialogue. The BLE Component should be available in your .cysch file.
Regards,
- Madhu Sudhan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I can not find the BLE Component Settings.
Could I find it in project?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Open the "TopDesign" window in the workspace explorer. Here you find all the components that have been selected for the project. When there is no BLE component yet, pick it from the component window and drop it onto your schematic. Now configure it accordingly (right click or double click)
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
Now I find the settings. But I get the same result that I send over UART.
I don't know what to do.