- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,Guys
I run the "BLE_FindMe" Code example on the CY8C4247LQI-BL483 Module.At first,everything is ok.After I put the IMO clock switch to ECO clock and rebuild the project,then download to CY8C4247LQI-BL483.When I reset the CY8C4247LQI-BL483 Module,advertisement stopped.
My question:
1、Why would stop broadcasting?(I just changed the clocks, the rest are not changed)But the ECO clock used by BLE subsystem and can also be used to run the cpu.
Configure System Clocks as attachment.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you test, e.g. by toggling a pin, that the module indeed runs properly with the correct frequency?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,hli
When I debug the project and check the 24MHz crystal oscillator by oscilloscope,I found that 24MHz clock is ok,and CyBle_ProcessEvents() can't be called but BLE_bless_isr_Start() function is called again and again .
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
That seems as if something is causing your code to start over and over?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I just changed the clocks, the rest are not changed.I think the underlying code may have a problem