- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
After checking
Figure 20. CYBLE-022001-EVAL Board Pinout in Spec
and PRoC BLE in PSoC Creator 3.2
There is a bug in Spec and the board
In CYBLE-022001-EVAL Board Pinout,
the pin P1_3 should change to P4_0 with red color
and then publish a new board for it
becuase EZ-Module P4_0 need to connect to this pin.
I think it is a layout bug
- Labels:
-
BLE
-
ispn:40067:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
We don't get your point .I checked it again and I don't any difference.
In creator there is no eval board option. There is only CYBLE-022001-00.
Please give exact pionters of the error that you found out.
Regards,
Vikas
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi VAVC:
(1)
See the attched file
http://www.cypress.com/?docID=54133
The picture is from Cypress specification
Look the left -side in this picture and you will see that P1_3
Actually there is no P1_3 in EZ-Module
(2)
By the way, EZ-Module has P4_0 (Open PSoC Creator and you will see it)
But there is no P4_0 on the green EVAL board.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1) There is no pin 1_3 on the CYBLE-022001-EVAL board/chip. It sounds like you are suggesting redoing the layout to have pin 4_0 replace the pin 1_3 on the pioneer board only?
2) The EVAL board is mainly for evaluation purposes I would suspect, and thus you only need to verify that the chip will do what you want? Why do you need access to the pin 4_0 specifically? Any of the other pins already broken out should be good enough to demonstrate functionality for the chip.