Announcements
Community Announcement : Welcome to the NEW Cypress Developer Community.
cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

Anonymous
Not applicable

Off the shelf example on PSOC42 and ble 042 kit. No modification.
 Debugging mode

   

1. I'm able to receive data from psoc

   

2. I detect with logic analyzer correct data stream into psoc (commands like 'c' etc)

   

3. Psoc don't respond neither with error nor with any valid character

   

Standard pinout is 1.5 tx 1.4 Rx

0 Likes
1 Solution
Anonymous
Not applicable

I found the reason. Rx pin don't tolerate resistor in series. 1K is too much

View solution in original post

0 Likes
2 Replies
Anonymous
Not applicable

Second question: Why I cannot choose block for UART I need?

   

I would like to use scb1, but there is no choise at all

0 Likes
Anonymous
Not applicable

I found the reason. Rx pin don't tolerate resistor in series. 1K is too much

View solution in original post

0 Likes