- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I'm starting with the Pioneer Kit and want to use an easy HW-Connection to link the switch (P0_7) with the input of a counter to count down 3 button presses to switch on the red LED (P3_4).
Unfortunately i get an error when i check the HW connection on the digital input pin with the Drive Mode "Resistive pull up".
This is the error message:
Pin 0: Use of drive modes which are not High Impedance with a hardware-routed input requires a port adapter, but the selected device does not have one.
Can somebody explain, which is the meaning of this message?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Too many possibilities, can you please post your complete project, so that we all can have a look at all of your settings. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Bob,
in the meantime i found the answer:
Described on page 37 in the Pins datasheet --> Some devices, such as PSoC 4000 series do not have Port Adapters and this limits some pin features.
In this case i have to use my CY8CKIT-042-BLE to test it again.