Announcements
Community Announcement : Welcome to the NEW Cypress Developer Community.
cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

Anonymous
Not applicable

Hi All,

   

I am facing issues in programming CYBLE-00120011-00 module,

   

I want to Erase the code on CYBLE-00120011-00 module

   

can it be done?how to do it?

0 Likes
1 Solution
AnjanaM_61
Moderator
Moderator

Hi sagard,

   

Bob is correct. Without module detecting to the Programmer, you won't be able to erase/program  the device again.

   

Could you please check the power supply to the module is proper? Can you please give the screenshot of Port settings of your programmer?

   

Thanks,
Anjana

View solution in original post

0 Likes
5 Replies
Bob_Marlowe
Expert II

You will need something like a programmer. Two choices:

   
        
  • The lab solution: Get a prototyping kit (for instance a CY8CKIT-043) with a snap off kitprog programmer.
  •     
  • The professional solution: Get a Miniprog 3
  •    
   

 

   

Bob

0 Likes
Anonymous
Not applicable

Hi Bob,

   

Thanks for reply,

   

I am already using Miniprog 3 and PSOC programmer application,

   

but the issue is one of the modules i have is not detecting in application,

   

other are detecting so i thought may be by erasing the previous code i can detect that module but it not working,

   

any known issues for CYBLE 0120011-00 module to not detect?

0 Likes
HeLi_263931
Honored Contributor II

You cannot delete a program from a module, only program another one onto it.

0 Likes
Bob_Marlowe
Expert II

When the module is not detected you do not get access to it, hence no erasing or re-programming. Usually the cause is a bad soldering.

   

 

   

Bob

0 Likes
AnjanaM_61
Moderator
Moderator

Hi sagard,

   

Bob is correct. Without module detecting to the Programmer, you won't be able to erase/program  the device again.

   

Could you please check the power supply to the module is proper? Can you please give the screenshot of Port settings of your programmer?

   

Thanks,
Anjana

View solution in original post

0 Likes