Announcements
Community Announcement : Welcome to the NEW Cypress Developer Community.
cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

Anonymous
Not applicable

I'm in "learn mode" and currently seeing where I get when testing out PSoC101 training video examples using a BLE PROC module. I'm expecting some incompatibilities. Is this one of them.

   

I'm on lesson 4 (Hardware pins) and found that this would not work for me as get the following error when compiling: "Pin guidance unavailable: 'Pin_SW1(0)' cannot be placed at P4[1]. P4 cannot be used for routed connections. "

   

Just wondering whether this is an error on my part with my TopDesign schematic or whether this is a limitation with BLE PROC itself.

0 Likes
3 Replies
Bob_Marlowe
Expert II

Just wondering whether this is an error on my part with my TopDesign schematic or whether this is a limitation with BLE PROC itself.I

   

Neither. The PSoC4 and PRoC have restrictions with routing signals to ports >= 4. When you remove the hardware connection from the pin component you will be able to assign it to a port 4 pin.

   

 

   

Bob

0 Likes
Anonymous
Not applicable

Wow would never have worked this one out. Pretty awesome. Have reconfigured my switch to P0.4 and it works! Thanks again.

0 Likes
Bob_Marlowe
Expert II

You are always welcome!

   

 

   

Bob

0 Likes