Sep 09, 2016
12:05 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 09, 2016
12:05 PM
Hello,
can I use 3.3V power supply for board CY8CKIT-043 and debugging with integrated debugger over USB with 5V power supply?
Power supply from debugger to board is disconnect.Can I destroy the board?
Thank you
Solved! Go to Solution.
Labels
- Labels:
-
ispn:39613:1:0
-
l1:314:1:0
1 Solution
Sep 09, 2016
12:45 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 09, 2016
12:45 PM
Welcome in the forum!
Can I destroy the board? Yes, easiest would be using a hammer. 😉
For using 3.3V have a detailed look at the Prototyping Kit Guide chapter 4.2.3 regarding the removal of a diode.
Bob
1 Reply
Sep 09, 2016
12:45 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 09, 2016
12:45 PM
Welcome in the forum!
Can I destroy the board? Yes, easiest would be using a hammer. 😉
For using 3.3V have a detailed look at the Prototyping Kit Guide chapter 4.2.3 regarding the removal of a diode.
Bob