Microcontrollers Forum Discussions

Hello,

I am investigating possibilities to use FlexRay (E-Ray) message RAM for the custom debug purposes, as FlexRay communication will not be needed.

Can it be accessed directly by the CPU core? If yes, what would be the starting address of the Message RAM?

Controller I am using is AURIX TC36x (SAK-TC364DP-64F300F AA).

Thanks for your support,
BR,
Djordje

1. Whether to use ADC or comparator for counter electromotive force

2. Is it only necessary to change the pole pair number to change the motor?

smartconx_target@Q!w2e3r4t5y6u7i8o9p0||/t5/MOTIX-MCU/motix-%E5%8F%8D%E7%94%B5%E5%8A%A8%E5%8A%BF-BLDC-BC-BEMF-EXAMPLE-TLE987X/td-p/744904

Hi,

I  want to configure my UART module  

TX should happen with 10US that i have configured with GPT ,

RX should happen with Interrupt based. 

same when i tested RX got struck in IfxStm_isDeadLine(inline) function.

I want to know why it is getting strucked

Hi I can use 

sendUARTMessage(msg, count)

Hi,

I'm looking for an complete example for using an external memory  (CY15B104QSN) with DSPI in modusToolbox.

My test board is the KIT_XMC72_EVK XMC7200 evaluation kit.
I did find a lot of code snippets, but none of them are complete using the device configurator and the QSPI configurator and finally having all steps from the initialisation till reading and writing from/to the device.

The board connector is J21 which I use.

Support is highly aprechiated.

BR

Martin

Hi,

I am using CY8C6245LQI-S3D42 and I used the DFU examples to boot the system and created the application to run on AM4 core and everything is working well. 

I wait for 5 sec in DFU to check if there is any updates or just move with the Application code.

I find that sometimes the device stops booting once in a blue moon. Now If I flash again just the boot loader, everything is fine , I need not have to write the Application, it moves from DFU in 5 sec to application.

I believe, there is some how the flash/DFU is getting corrupted.  I want to protect this scenario. Can some one share how do I protect my DFU so that it never erases . Any example's will be appreciable, I am using USB CDC transport in DFU.

Regards,

Madhav

I use  PP_ComLib_Wrapper.dll in my project. I have created an object with that dll: 

static PP_ComLib_WrapperClass pp = new PP_ComLib_WrapperClass();

and when i try to use the function USB2IIC_DataTransfer , i come up with this error: "I2C_PerformTransaction() is not implemented by this Programmer".

And also when i try to use the function USB2IIC_SendData , i get this one: "USB2IIC_SendData() not implemented for this programmer!"

How can i solve this error? What should i do? I use kitprog 3 "KitProg3 (Bridge/0C170AEE00162400)"