- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all:
I use the CY8PROTO-062-4343W board. And i create a ModusToolBox new application about Hello_World. I can build the project, but some problems when debug the project.
Quick Panel of Lauches does not show "HelloWorld Debug(KitProg3)".
Add new configurations on Debug Configurations of GDB OpenOCD Debugging, "Config options" has noting information in "Debugger" option.
ps: I can use Cypress Programmer 3.0 to program the board.
Info : [CyBridge] Start API initialization
Info : [CyBridge] Hardware initialization complete (955 ms)
Info : Connected - KitProg3 CMSIS-DAP BULK-1E1613D900078400 FW Version 1.21.707
Info : Selected Device: CY8CPROTO-062-4343W-1E1613D900078400
Thanks.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi yuqi_1327861,
I think the launches are not generated properly. Can you please regenerate the launches by clicking on Generate Launches in the Quick Panel and then try again?
Please let me know if you are able to program/debug the device after that.
Thanks and Regards,
Rakshith M B
Rakshith M B
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi yuqi_1327861,
I think the launches are not generated properly. Can you please regenerate the launches by clicking on Generate Launches in the Quick Panel and then try again?
Please let me know if you are able to program/debug the device after that.
Thanks and Regards,
Rakshith M B
Rakshith M B
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi RakshithM_16,
I can program and debug the device after regenerate launches.
Thanks.