Announcements
IMPORTANT: Cypress Developer Community is transitioning on October 20th. To learn more and be prepared for this change, check out our latest announcement.
cancel
Showing results for 
Search instead for 
Did you mean: 

Knowledge Base Articles

Use of Port B for Data bus while using INT1 pin from Port C

Anonymous
Not applicable

Use of Port B for Data bus while using INT1 pin from Port C

Question: I want to use the INT1 pin as a strobe (for example when the converter samples, it sends the strobe to the core and it reads the byte and sends it), but the INT1 pin is on PORT C, so I can't use all 8 port C pins as I/O pins. Which pins should I use to get the byte of data? Can I use the 8 8051 data bus pins and how?

 

Answer:

That is correct, you'll have to sacrifice the INT1 alternate function if you want to use all 8 lines on port C. The data bus for this package can only be used in conjunction with the fast transfer feature to move data. The strobes coming from the 2135 would then be FWR# and FRD# (alternate functions of PA4/PA5). The 2131 has the Port B you're looking for.

0 Likes
Version history
Revision #:
1 of 1
Last update:
‎Dec 19, 2008 12:00 AM
Updated by:
Anonymous
 
Contributors