Announcements
IMPORTANT: Cypress Developer Community is transitioning on October 20th. To learn more and be prepared for this change, check out our latest announcement.
cancel
Showing results for 
Search instead for 
Did you mean: 

Knowledge Base Articles

TDO Output of the JTAG circuitry

Anonymous
Not applicable

TDO Output of the JTAG circuitry

Question: When Boundary Scan input signals are applied to TDI, TCK and TMS pins of the chip, no output signal can be detected from TDO pin of the chip. What is the problem?

 

Answer:

The TDO by default will be in a Hi-Z mode except during the Shift-IR and Shift-DR states. The former state puts out the data from the Instruction register and also the data from the TDI. The latter state puts out the data from the data register and the data from the TDI. In all the other states, TDO will be in a Hi-Z state. For further information regarding the complete operation of JTAG please refer to the JTAG IEEE 1149.1 specification.

0 Likes
Version history
Revision #:
1 of 1
Last update:
‎Jun 18, 2011 12:49 PM
Updated by:
Anonymous
 
Contributors