Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
Significance of HOTLink claim of requiring no external PLL components?
Question: What is the significance of the HOTLink claim of requiring no external PLL components?
HOTLink Transmitter and Receiver have completely integrated PLL clock multiplier (CMU) and data separator functions (CDR). These functions are implemented with high-performance phase-locked loops (PLLs) that have been tuned for maximum performance and minimum system noise sensitivity. In competitive products that claim to offer similar functions, these PLL's are often implemented with external filter and frequency setting components with the goal of achieving maximum performance. These very same external components are the largest cause of end-user complaints and random system failures because they expose the most critical analog signals in the circuit to the external noises that abound in normal systems. External components require critical, costly and time consuming printed circuit board layout as well as high-speed analog and digital design techniques that are unfamiliar to many system integrators. HOTLink products are designed and built using fully differential analog and digital circuits to give the lowest possible output jitter and highest possible jitter tolerance. There are no external components to compromise system performance in unexpected and unpredictable ways. For more information, refer to the HOTLink Transmitter Jitter section of the "HOTLink Jitter Characteristics" application note.