Announcements
IMPORTANT: Cypress Developer Community currently doesn’t allow sign-in to prepare for the upcoming transition. To learn more, check out our announcement.
cancel
Showing results for 
Search instead for 
Did you mean: 

Knowledge Base Articles

Meaning of bit 2 in register 0x05 of the SL811HS

Anonymous
Not applicable

Meaning of bit 2 in register 0x05 of the SL811HS

Answer:

Question:In the Emb_host firmware and in the source code given by "SL811HS/SL811HST Application Notes" at page 27 register 0x05 is being written with 0x05, which means a reserved bit is being set, why?

 

Response: 

The Control Register (address 0x05) is defined as shown below (see data sheets for more information):

                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                         
BitSL811HS - HostSL811HS - Slave
0SOF EnableUSB Enable
1ReservedDMA Enable
2ReservedDMA Direction
3USB Engine ResetJ-K Force state bit 0
4J-K state forceJ-K Force state bit 1
5USB SpeedSpeed select
6SuspendTransceiver Standby
7ReservedReserved

 

 

In the referenced documents the writer was setting bit 2, but as can be seen in host mode this bit has no meaning. While the application note mentioned is from an obsolete development kit and is a good source of information, it should be used with caution because several errors have been found in it. It does not hurt to set the Reserved bit in Host mode but in practice it should be set to 0. Note that when operating in Slave mode this bit does have a meaning in regards to the DMA operation. Another thing to note is that the SL811HS errata mentions issues with regards to DMA operation so even in Slave mode DMA is not recommended.

 

Related Links:

CY3662 Development Kit

 

Attachments
0 Likes
Version history
Revision #:
1 of 1
Last update:
‎Dec 19, 2008 12:00 AM
Updated by:
Anonymous
 
Contributors