Announcements
IMPORTANT: Cypress Developer Community is transitioning on October 20th. To learn more and be prepared for this change, check out our latest announcement.
cancel
Showing results for 
Search instead for 
Did you mean: 

Knowledge Base Articles

Hub Iniates Communication - Node in Receive Mode

Anonymous
Not applicable

Hub Iniates Communication - Node in Receive Mode

Question: In a non-battery powered application, can the node be left in receive mode such that the hub can initiate communications?

 

Answer:

Yes. In fact, the CyFi Star Network Protocol has this specific configurable attribute available in the PSoC Designer application development software. There are three available power options which change the behavior of the CyFi node device based on this power setting: High-Impedance Battery (e.g, coin cell/CR2032) - results in a 5ms receive mode and then sleep during idle; Low-Impedance Battery (e.g. AAA batteries) - results in a 50ms window of receive mode after a transmit and then sleep during idle; Wall-Powered - results in receive-mode during idle.

0 Likes
Version history
Revision #:
1 of 1
Last update:
‎Feb 17, 2009 12:00 AM
Updated by:
Anonymous
 
Contributors