Error Codes Returned when Programming a PSoC® 1 Device Using CY3207ISSP Programmer Through DOS Commands - KBA83340
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Version: **
Translation - Japanese: DOSコマンドを介してCY3207ISSPプログラマーを使用してPSoC®1デバイスをプログラミングするとエラーコードが返される- KBA83340 -
Question:
What do the negative error codes that are returned when attempting to program a PSoC® 1 device using CY3207ISSP programmer through the DOS command line interface?
Answer:
You can program PSoC® 1 devices using CY3207ISSP programmer through DOS commands by following the procedure described in section 3.4 of the CY3207ISSP ISSP Guide (http://www.cypress.com/?docID=33767). These DOS commands return ‘0’ if the function is successful and a negative number if the function fails as indicated below:
"-1” - Communication error. Unable to communicate with the device to be programmed.
"-2” - No hex file loaded.
"-3” - Silicon ID mismatch. Silicon ID of part does not match selected part number.
"-4” - Incorrect Checksum.
- Tags:
- psoca 1
-
This widget could not be displayed.Anonymous