- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
Working with a fresh install of Designer 5.4 SP1.
When attempting to build the following errors are thrown:
name translation failed on C:/Program\ Files\ (x86)/Cypress/PSOCDE~1/5.4/Common/CYPRES~1 - 3
name translation failed on C:\Program - 2
name translation failed on Files - 2
name translation failed on (x86)\Cypress\PSOCDE~1\5.4\Common\CYPRES~1\tools\include\CY8C22~2 - 3
make: *** No rule to make target `C:\PSoC', needed by `lib/obj/i2chwcommon.o'. Stop.
B4347c1 - 1 error(s) 0 warning(s) 08:54:30
I attempted one 'fix' by following the directions at the bottom of the thread found here, but the error still persists after the reinstall.
This project was created on an 'old' workstation that has been replaced, the project was copied over to this new workstation without being modified in any way.
Any ideas?
- Labels:
-
PSoC 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I would suggest to post in the PSoC1 forum. Which PSoC chip are you using?
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This design uses the CY8C22345-24SXIT.