- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I currently have a CYBLE-214009-00 on a custom board, when power is added as seen in the datasheet, I don't pick up a bluetooth signal on another device. Is programming to the module required? if so how can i program this module?
Thanks,
Nicolas
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Nicolas,
The module CYBLE-214009-00 should come pre-programmed with EZ-Serial firmware ( If module shipped (from our factory) after 1/1/2017) and should be advertising by default. If the module was shipped from older inventory shipped previously, then it would not be. You can download the firmware image from the below link. http://www.cypress.com/documentation/software-and-drivers/ez-serial-ez-ble-module-firmware-platform
Regards,
Gyan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Nicolas,
The module CYBLE-214009-00 should come pre-programmed with EZ-Serial firmware ( If module shipped (from our factory) after 1/1/2017) and should be advertising by default. If the module was shipped from older inventory shipped previously, then it would not be. You can download the firmware image from the below link. http://www.cypress.com/documentation/software-and-drivers/ez-serial-ez-ble-module-firmware-platform
Regards,
Gyan