3 Replies Latest reply on Aug 23, 2017 5:22 AM by pieter_2521576

    Feature request: separate system settings (Debug Select; Chip Protection) for Debug and Release build

    pieter_2521576

      Hi Cypress,

         

      See attached screenshots. It would be great if you added a feature so that the system settings would change, depending if it was a Debug or a Release build.

         

      For Debugging, I want to allow SWD and the chip protection must be set to Open. For Release, Debug Select should be set to GPIO and Chip Protection must be set to Protected (for obvious reasons).

         

      The same goes for the Bootloadable block. For debugging, it should use the HEX file in the Debug directory and for release, it should use the HEX file in the Release directory.

         

      The manual process of changing the settings (in the bootloadable AND bootloader) is error-prone and I could make a mistake and release a product without the protection bits set :(

         

      Thanks in advance,

         

      Pieter