- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In order to examine sleep-mode of the Anaren A20737 I have the timer interrupt running at 1 sec, disabled scan & adv, and putting it into sleep.
One module sends a trace msg every second as expected.
I then programmed the same hex file into modules form a different batch.
These also go to sleep and but no more 1-second messages are sent. Seems the timer went also to sleep.
How can this happen?
Aren't all modules identical?
Solved! Go to Solution.
- Labels:
-
Sleep Modes
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Bartels,
All Anaren modules are built identical and have been tested 100% before getting shipped out. We canot switch any discrete componenet without informing the regulatory authority as the RF matching circuity is FCC compliant and any change can lead to non compliance. Can oyu please take a high resolution pic of the 2D code on top of the modules [the working and non working ones] and send them to atmosphere@anaren.com so that we can check the test results. it will also help if you can upload your WICEd source code as well as the schematics of your PCB here for us to replicate your issue.
Hope this helps.
-MD
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The modules are identical and it should have the same behaviour. I assumed you used Amosphere from Anaren for the development and I have added Anaren folks here for comments.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I used WICED, not Amosphere
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Bartels,
All Anaren modules are built identical and have been tested 100% before getting shipped out. We canot switch any discrete componenet without informing the regulatory authority as the RF matching circuity is FCC compliant and any change can lead to non compliance. Can oyu please take a high resolution pic of the 2D code on top of the modules [the working and non working ones] and send them to atmosphere@anaren.com so that we can check the test results. it will also help if you can upload your WICEd source code as well as the schematics of your PCB here for us to replicate your issue.
Hope this helps.
-MD