- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
RH readings from wiced sense 2 using the official android app seems to be 15 to 20 units (RH %) higher than real RH.
Also the RH reading is not updated (waited 10 min) ; is updated only when I disconnect and reconnect.
The temperature is updated quite often, it seems OK.
Has anybody noticed the same?
Thank you for reading.
Adrian Fabry
Solved! Go to Solution.
- Labels:
-
WICED Sense
- Tags:
- rh
- wiced sense 2
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I followed Gavin Beattie's suggested fix in the below thread:
Re: Are there any issues with Wiced Sense temperature and humidity response?
I observed on my Android app (v1.08) that the humidity and temperature readings were updated rather quickly, e.g. within 2s after I
blow my breath at my SENSE 1 PCB board. This was also the same observation on my trace. Do give it a try.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I followed Gavin Beattie's suggested fix in the below thread:
Re: Are there any issues with Wiced Sense temperature and humidity response?
I observed on my Android app (v1.08) that the humidity and temperature readings were updated rather quickly, e.g. within 2s after I
blow my breath at my SENSE 1 PCB board. This was also the same observation on my trace. Do give it a try.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Many thanks btta, that's good news. I hope it will work on wiced sense 2 also.
I still need to learn how to use the SDK to make the modification and upgrade the firmware.